After finding good garage door installation in Calgary, another necessary step as a garage owner is to figure out how to program your garage door opener. Not everyone can be tech-savvy, making it difficult to enjoy the convenience of remotely opening and closing your garage door when needed.
If you’re struggling to program your garage door opener, here is what you can do to get everything set up and in working order!
The Type of Garage Door Opener
Before programming your garage door opener, you must ensure you’re using the right type of garage opener remote. In which case, check for the manufacturer and model information on the motor unit found on the garage ceiling or the external receiver near the wire antenna. You can find a remote that speaks to those specifications from that information. For the most part, it’s recommended for those with older garage door models to go that route since universal remotes have been said not to work with them. Meanwhile, if you have a newer garage door opener and are unsure of its model, you can rest assured that a universal remote will work nicely.
Setting Up Garage Door Opener
Once you figure out the model and the remote, you can start to program your garage door opener.
First, you would want to locate where the ‘learn’ button is on the power box that connects to the garage door. Once you do, you will need a ladder to reach the one side of the power box that will pop off and fold down. It will reveal a light bulb, wires, and this button that you will push. You will notice a small light next to the button will come on.
Take that as the signal to press the main button on your garage door remote. You can tell if you successfully programmed your garage door opener by seeing its light start to blink. The remote should automatically determine the right radio frequencies for your garage door opener in this way. Afterwards, close up the power box and test out the remote.
However, it may be more confusing if you’re using a universal remote since you will need to first set the dip switches on the remote to indicate the garage door opener brand, then the radio frequency.
Programming Opener Without a Remote
Typically, you can’t program a garage door opener without a remote. However, there are a few ways around it. One uses your remote transmitter to reset the garage door opener buttons inside your car. Alternatively, you can always use an electronic keypad to control the door without a remote by pressing the arrow buttons and the program buttons simultaneously.
For all your residential and commercial garage door services in Calgary, trust the experts at Aladdin Garage Doors. Whether you need a garage door repaired or you need a new one installed, we are the professionals for you. Our technicians are highly trained to handle any job you need to be done. We sell top quality garage doors and sections, as well as remote controls, inside wall units and additional accessories. It doesn’t matter if you need new garage doors or garage door repairs in Calgary, we’re the family-owned business for you. Get the team that will make you 110% satisfied. Call us on 403-908-0999 today.
Connect With Us On Social Media